adsense analytic

Tuesday, June 25, 2019

Methods of concrete cube test

In concrete compression test, generally the concrete cube samples with dimensions 150mmx150mmx150mm are utilized. But, in place of 150mmx150mmx150mm concrete cube samples, 100mmx100mmx100mm concrete cube samples are applied for the test.

Fundamentally, the force produced through a concrete compression machine is a definite value. For the use of normal concrete strength, suppose under 50MPa, the stress provided by a 150mmx150mmx150mm cube is adequate for the machine to smash the concrete sample.

However, when the intended concrete strength is 100MPa, under the equivalent force (about2,000kN) delivered by the machine, the stress under a 150mmx150mmx150mm cube is inadequate to crush the concrete cube.

So, 100mmx100mmx100mm concrete cubes are used in place of 150mmx150mmx150mm cubes to raise the used stress to crush the concrete cubes. For normal concrete strength, the cube size of 150mmx150mmx150mm is already sufficient for the crushing strength of the machine.

Cube Test:

Instrument And Material.

Concrete cube mould with size 150mm or 100mm is applied for aggregate size of not more than 40mm and 25mm. Cube mould for test should be formed into steel or cast iron containing smooth inner surface. Each mould should contain steel plate to support and avoid leakage.

Compacting steel rod should be used with 16mm diameter and 600mm length.

The test should be conducted by compression test machine.

Method: Mould and base plate should be cleansed and employed with oil so that the concrete can’t fix to the side of the cube. Base plate is affixed to the mould with bolt and nut.
The cube should be filled with concrete in three layers.

Each layer should be consolidated for 25 times. This process should be accomplished systematically and compaction should be finished equally to all the surfaces of the concrete. Compaction is also done with machine.

The surface of concrete should be leveled to retain the equivalent level with the upper side of the mould.

Cubes which are produced at construction site should be wrapped with plastic cover for a period of 24 hours prior to remove the moulds.

After remoulded, the concrete cubes should be drowned in water for curing.
Compression strength test should be conducted for concrete at age 7, 14, and 28 days through compression test machine.

Result: The Strength value of each cube should be noted and compared with the targeted strength value. The reason for conducting the concrete test on 7 th day and the 14 th day is to anticipate whether the concrete could attain the targeted 28 th day strength. Normally, concrete can obtain 70% strength on the 7 th day.


Methods of concrete cube test

~~~~~~~~~~~~~~~~~~~~~~~~
Published By
Rajib Dey
www.constructioncost.co
~~~~~~~~~~~~~~~~~~~~~~~~

No comments:

Post a Comment